Fusion FWD V6-3.0L (2009)
Removal and Installation
1. NOTE: Module configuration is only required if a new audio Digital Signal Processing (DSP) module is being installed.
Upload the audio DSP module configuration information to the scan tool.
2. Remove the 4 pushpins and the RH luggage compartment trim panel.
3. Disconnect the audio DSP module electrical connectors.
4. Remove the 3 bolts and the audio DSP module.
-
To install, tighten to 9 Nm (80 lb-in).
5. To install, reverse the removal procedure.
-
Download the configuration information to the audio DSP module.
Accessory Protocol Interface Module (APIM)
Accessory Protocol Interface Module (APIM)
NOTE: Fusion, Milan shown, MKZ similar.
