Fusion FWD V6-3.0L (2009)
Rear Door Panel: Service and Repair
Door Trim Panel - Rear
NOTE: Fusion shown, Milan and MKZ similar.
Removal and Installation
NOTE: RH side shown, LH side similar.
1. Remove the rear door inside handle bezel screw cover.
2. Remove the upper rear door inside handle bezel screw.
3. Remove the rear door inside handle bezel.
-
Lift upward on the rear of the rear door inside handle bezel.
-
Disconnect the electrical connector.
4. Remove the rear door handle screw cover.
5. Remove the rear door handle screw.
6. Remove the rear door trim panel upper screw.
7. NOTE: The back of the rear door trim panel shown with the location of the rear door trim panel pin-type retainers indicated.
Remove the rear door trim panel.
-
Pull the rear door trim panel outward to release the rear door trim panel pin-type retainers.
