Fusion FWD V6-3.0L (2009)
For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result in serious
personal injury.
NOTICE: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it
with water.
1. Remove the degas bottle.
2. Disconnect the ABS module electrical connector.
3. Disconnect the brake tube fittings.
-
To install, tighten to 17 Nm (150 lb-in).
4. Remove the Hydraulic Control Unit (HCU) bracket-to-frame nut.
-
To install, tighten to 23 Nm (17 lb-ft).
5. NOTE: If installing a new bolt, use only the Torx head type for vehicles equipped with a 3.5L engine.
Remove the HCU bracket-to-frame bolt.
-
To install, tighten to 23 Nm (17 lb-ft).
6. Remove the HCU bracket-to-frame stud.
-
To install, tighten to 23 Nm (17 lb-ft).
7. Remove the HCU and bracket.
8. Remove the HCU bracket-to-HCU bolt and remove the bracket.
-
To install, tighten to 9 Nm (80 lb-in).
9. NOTE: Make sure the HCU and ABS module are clean and free of any brake fluid or foreign material before separating the components.
To install, reverse the removal procedure.
-
Bleed the brake system.
