Fusion FWD V6-3.0L (2009)
5. Remove the short brake tubes and install the master cylinder brake tubes.
-
Tighten to specifications, refer to Specifications.
6. Bleed each brake tube at the brake master cylinder as follows:
1. Have an assistant slowly pump the brake pedal, and then hold firm pressure on the brake pedal.
2. Loosen the rear-most brake tube fittings until brake fluid comes out. While the assistant maintains pressure on the brake pedal, tighten the
brake tube fitting.
3. Repeat this operation until clear, bubble-free fluid comes out.
4. Refill the brake master cylinder reservoir as necessary. Repeat the bleeding operation at the front brake tube.
