Fusion FWD V6-3.0L (2009)
Brake Master Cylinder: Removal and Replacement
Brake Master Cylinder
Brake Master Cylinder - 2.3L and 3.0L
NOTE: Automatic transmission with standard ABS shown, manual transmission similar.
Removal and Installation
WARNING: Do not use any fluid other than clean brake fluid meeting manufacturer's specification. Additionally, do not use brake fluid that
has been previously drained. Following these instructions will help prevent system contamination, brake component damage and the risk of
serious personal injury.
WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice.
For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result
in serious personal injury.
NOTICE: Do not spill brake fluid on painted or plastic surfaces or damage to the surface may occur. If brake fluid is spilled onto a painted or
plastic surface, immediately wash the surface with water.
1. Disconnect the brake fluid level warning switch electrical connector.
2. Using a suitable suction device, remove the brake fluid from the brake master cylinder reservoir.
3. If equipped with a manual transmission, disconnect the clutch master cylinder feed hose.
-
Plug the clutch master cylinder feed hose.
4. Disconnect the brake tube fittings, plug the brake tubes and the brake master cylinder ports.
-
To install:
-
On vehicles equipped with Electronic Stability Control (ESC), tighten to 28 Nm (21 lb-ft).
