Fusion FWD V6-3.0L (2009)
Automatic transmission vehicles
7. NOTE: It is not necessary to remove the fluid level indicator tube from the transmission. The tube can be positioned aside with only the bolt
removed.
Remove the transmission fluid level indicator tube bolt and position the tube aside.
-
To install, tighten to 8 Nm (71 lb-in).
All vehicles
8. Remove the brake booster push rod pin and clip and disconnect the push rod from the brake pedal.
9. Remove the 4 nuts and the brake booster.
-
To install, tighten the nuts in a criss-cross pattern to 23 Nm (17 lb-ft).
10. NOTICE: Prior to installation, make sure that the distance between the booster mating surface and the push rod centerpoint is as shown
or reduced brake assist may occur.
To install, reverse the removal procedure.
-
Check for correct booster push rod distance and adjust as necessary.
-
Tighten the booster push rod jam nut to 17 Nm (150 lb-in).
