Fusion FWD V6-3.0L (2009)
3. Position the valve cover and install the bolts and stud bolts.
-
Tighten in the sequence shown to 10 Nm (89 lb-in).
4. Position the wiring harness and attach the 2 pin-type retainers to the valve cover.
5. Attach the 2 wiring harness retainers to the valve cover stud bolts.
6. Attach the wiring harness retainer to the upper intake manifold.
7. Position the oil level indicator tube and install the stud bolt.
-
Tighten to 9 Nm (80 lb-in).
8. Install the oil level indicator.
9. Attach the power steering tube retainer to the valve cover stud bolt.
10. Connect the LH HO2S electrical connector and pin-type retainer.
11. Connect the VCT solenoid electrical connector.
12. Install the crankcase ventilation tube.
13. Install the LH ignition coil-on-plugs.
