Fusion FWD V6-3.0L (2009)
7. Release the heater hoses clamps and disconnect the hoses from the heater core
8. Remove the 6 heater core and evaporator core housing nuts.
-
To install, tighten to 9 Nm (80 lb-in).
9. Remove the heater core and evaporator core housing.
10. To install, reverse the removal procedure.
-
Install new gasket seals.
-
Lubricate the refrigerant system with the correct amount of clean PAG oil.
11. Fill the engine coolant level.
12. Evacuate, leak test and charge the refrigerant system.
