Fusion FWD V6-3.0L (2009)
14. NOTICE: Inspect the mating surfaces of the FP module flange and the fuel tank O-ring seal contact surfaces. Do not polish or adjust the
O-ring seal contact area of the fuel tank flange or the fuel tank. Install a new FP module or fuel tank if the O-ring seal contact area is
bent, scratched or corroded.
NOTE: To install, apply clean engine oil to the new O-ring seal.
Remove and discard the FP module O-ring seal.
15. To install, reverse the removal procedure.
-
Make sure the alignment tab on the FP module and the fuel tank meet before tightening the FP module lock ring.
