Fusion FWD V6-3.0L (2009)
All engines
15. If equipped, detach the engine block heater harness from the power steering pressure line.
16. Remove the pressure line-to-steering gear banjo bolt and remove the pressure line.
-
Discard the bolt and the 2 seals.
-
To install, tighten the new bolt to 55 Nm (41 lb-ft).
17. NOTICE: New banjo bolts and new seals must be installed any time the power steering pressure line is disconnected from the power
steering pump and/or the power steering gear or a fluid leak may occur.
To install, reverse removal procedure.
18. Fill the power steering system.
