ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 2974 > < Initial Inspection and Diagnostic Overview|Page 2972
Page 5
background image

-

Are the resistances less than 5 ohms?

Yes

For FNR5 transaxles, GO to B3 .

For 6-speed transaxles, GO to B4 .

No

REPAIR the circuit in question. CLEAR the DTCs. REPEAT the network test with the scan tool.

-------------------------------------------------
B3 CHECK THE HS-CAN CIRCUITS BETWEEN THE FNR5 TRANSAXLE TCM AND THE DLC FOR AN OPEN

-

Disconnect: TCM C2352b.

-

Measure the resistance between the TCM C2352b-1, circuit VDB04 (WH/BU), harness side and the Data Link Connector (DLC) C251-6, circuit
VDB04 (WH/BU), harness side.

-

Measure the resistance between the TCM C2352b-13, circuit VDB05 (WH), harness side and the DLC C251-14, circuit VDB05 (WH), harness
side.

-

Are the resistances less than 5 ohms?

Yes

CONNECT the negative battery cable. GO to B5.

No

REPAIR the circuit in question. CONNECT the negative battery cable. CLEAR the DTCs. REPEAT the network test with the scan tool.

-------------------------------------------------
B4 CHECK THE HS-CAN CIRCUITS BETWEEN THE DLC AND THE 6-SPEED TRANSAXLE TCM FOR AN OPEN

-

Measure the resistance between the TCM C1533-14, circuit VDB04 (WH/BU), harness side and the DLC C251-6, circuit VDB04 (WH/BU),
harness side.

Initial Inspection and Diagnostic Overview|Page 2974 > < Initial Inspection and Diagnostic Overview|Page 2972