Fusion FWD V6-3.0L (2009)
I3 CHECK THE MS-CAN CIRCUITS BETWEEN THE HVAC MODULE AND THE DLC FOR AN OPEN
-
Measure the resistance between the HVAC module C228a-12 (single-zone) or C2356a-12 (dual-zone), circuit VDB06 (GY/OG), harness side and
the Data Link Connector (DLC) C251-3, circuit VDB06 (GY/OG), harness side.
-
Measure the resistance between the HVAC module C228a-13 (single-zone) or C2356a-13 (dual-zone), circuit VDB07 (VT/OG), harness side and
the DLC C251-11, circuit VDB07 (VT/OG), harness side.
-
Are the resistances less than 5 ohms?
Yes
CONNECT the negative battery cable. GO to I4.
No
REPAIR the circuit as necessary. CONNECT the negative battery cable. CLEAR the DTCs. REPEAT the network test with the scan tool.
-------------------------------------------------
I4 CHECK FOR CORRECT HVAC MODULE OPERATION
-
Disconnect all the HVAC module connectors.
-
Check for:
-
corrosion
-
damaged pins
-
pushed-out pins
-
Connect all the HVAC module connectors and make sure they seat correctly.
-
Operate the system and verify the concern is still present.
-
Is the concern still present?
Yes
INSTALL a new HVAC module. REFER to Heating and Air Conditioning. CLEAR the DTCs. REPEAT the network test with the scan tool.
No
The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector. CLEAR the DTCs. REPEAT the
network test with the scan tool.
-------------------------------------------------
Pinpoint Test J: The Parking Aid Module (PAM) Does Not Respond to the Scan Tool
Communications Network
Pinpoint Tests
Pinpoint Test J: The Parking Aid Module (PAM) Does Not Respond To The Scan Tool
Refer to Wiring Diagram Set 14, Module Communications Network for schematic and connector information. See: Diagrams/Electrical
