ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 3026 > < Initial Inspection and Diagnostic Overview|Page 3024
Page 57
background image

-------------------------------------------------
R42 CHECK THE MS-CAN (+) AND MS-CAN (-) CIRCUITS FOR A SHORT TO GROUND WITH THE DCSM DISCONNECTED

-

Disconnect: DCSM C3305c.

-

Measure the resistance between the DLC C251-3, circuit VDB06 (GY/OG), harness side and the DLC C251-11, circuit VDB07 (VT/OG), harness
side.

-

Are the resistances greater than 1,000 ohms?

Yes

CONNECT the negative battery cable. GO to R55.

No

GO to R43.

-------------------------------------------------
R43 VERIFY VEHICLE EQUIPMENT - SDARS MODULE

-

Inspect the vehicle for a Satellite Digital Audio Receiver System (SDARS) module.

-

Is the vehicle equipped with a SDARS module?

Yes

GO to R44.

No

GO to R45.

-------------------------------------------------
R44 CHECK THE MS-CAN (+) AND MS-CAN (-) CIRCUITS FOR A SHORT TO GROUND WITH THE SDARS MODULE
DISCONNECTED

-

Disconnect: SDARS Module C4300.

-

Measure the resistance between the DLC C251-3, circuit VDB06 (GY/OG), harness side and the DLC C251-11, circuit VDB07 (VT/OG), harness
side.

-

Are the resistances greater than 1,000 ohms?

Yes

CONNECT the negative battery cable. GO to R56.

No

GO to R45.

-------------------------------------------------
R45 VERIFY VEHICLE EQUIPMENT - APIM

-

Inspect the vehicle for an Accessory Protocol Interface Module (APIM).

Initial Inspection and Diagnostic Overview|Page 3026 > < Initial Inspection and Diagnostic Overview|Page 3024