Fusion FWD V6-3.0L (2009)
Yes
INSTALL the removed fuses. Go To Pinpoint Test B. See: Pinpoint Test B: The Transmission Control Module (TCM) Does Not Respond to the Scan
Tool
No
INSTALL the removed fuses. GO to U10.
-------------------------------------------------
U10 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE INSTRUMENT CLUSTER (IC) DISABLED
NOTE: When re-running the network test, the network test application must be first closed or the screen display will revert back to the prior run network
test results.
-
Disconnect: SJB Fuses 13 (10A), 23 (7.5A) and 27 (7.5A).
-
Enter the following diagnostic mode on the scan tool: Network Test.
-
Repeat the network test.
-
Do all other modules pass the network test?
Yes
INSTALL the removed fuses. Go To Pinpoint Test G. See: Pinpoint Test G: The Instrument Cluster (IC) Does Not Respond to the Scan Tool
No
INSTALL the removed fuses. GO to U11.
-------------------------------------------------
U11 VERIFY VEHICLE EQUIPMENT - APIM
-
Inspect the vehicle for an Accessory Protocol Interface Module (APIM).
-
Is the vehicle equipped with an APIM?
Yes
GO to U12.
No
GO to U13.
-------------------------------------------------
U12 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE APIM DISCONNECTED
NOTE: When re-running the network test, the network test application must be first closed or the screen display will revert back to the prior run network
test results.
-
Disconnect: APIM C3338.
-
Enter the following diagnostic mode on the scan tool: Network Test.
-
Repeat the network test.
-
Do all other modules pass the network test?
Yes
CONNECT the APIM. Go To Pinpoint Test Q. See: Pinpoint Test Q: The Accessory Protocol Interface Module (APIM) Does Not Respond to the Scan
Tool
No
GO to U13.
-------------------------------------------------
U13 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE RESTRAINTS CONTROL MODULE (RCM) DISABLED
