Fusion FWD V6-3.0L (2009)
Evaporative Emissions Hose: Service and Repair
Fuel Vapor Tube Assembly - Front Wheel Drive (FWD)
Removal and Installation
WARNING: Do not smoke, carry lighted tobacco or have an open flame of any type when working on or near any fuel-related component.
Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious personal injury.
WARNING: Do not carry personal electronic devices such as cell phones, pagers or audio equipment of any type when working on or near any
fuel-related component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in
serious personal injury.
WARNING: Always disconnect the battery ground cable at the battery when working on an evaporative emission (EVAP) system or
fuel-related component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in
serious personal injury.
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the battery ground cable.
3. Remove the 3 nuts and the fuel tank filler pipe heat shield.
-
To install, tighten to 10 Nm (89 lb-in).
4. Disconnect the Fuel Tank Pressure (FTP) sensor electrical connector.
5. Disconnect the fuel vapor tube assembly-to-fuel tank quick connect coupling.
6. Disconnect the fuel vapor tube assembly-to-Evaporative Emission (EVAP) canister quick connect coupling.
7. Release the 2 swivel clips and remove the fuel vapor tube assembly.
