Fusion FWD V6-3.0L (2009)
5. NOTE: This step will remove approximately one-eighth tank of fuel from a completely full fuel tank and the majority of any residual fuel from the
fuel tank filler pipe. Also, the fuel in the fuel tank will be below the fuel tank inlet for fuel tank filler pipe removal without fuel spillage.
Attach the Fuel Storage Tanker to the Fuel Draining Hose and remove approximately one-eighth tank of fuel (from a completely full tank),
lowering the fuel level below the fuel tank inlet.
6. Remove the 3 fuel tank filler pipe retaining screws.
7. Remove the LH rear wheel and tire.
8. Remove the 3 rivets, 6 pin-type retainers and the LH wheel splash shield.
9. Remove the fresh air hose fitting from the fuel tank filler pipe housing.
10. Remove the 3 nuts and the fuel tank filler pipe heat shield.
-
To install, tighten to 9 Nm (80 lb-in).
11. Remove the fresh air hose from the dust separator.
12. Remove the fuel tank filler pipe bracket nut.
-
To install, tighten to 10 Nm (89 lb-in).
13. Release the 2 swivel clips.
14. NOTE: Some fuel may remain in the fuel tank filler pipe after the initial drain. Carefully drain any residual fuel into a suitable container.
Release the clamp and disconnect the fuel tank filler pipe hose from the fuel tank.
-
To install, tighten to 4 Nm (35 lb-in).
15. Remove the fuel tank filler pipe assembly from the vehicle.
16. To install, reverse the removal procedure.
