Fusion FWD V6-3.0L (2009)
Removal and Installation
1. Remove the battery tray. For additional information, refer to Battery Tray See: Service and Repair/Battery Tray.
2. Remove the bolt, nut and the battery hold-down bracket.
-
To install, tighten to 10 Nm (89 lb-in).
3. Remove the bolt and position the battery cable body ground terminal aside.
-
To install, tighten to 12 Nm (106 lb-in).
4. Remove the nut and position the Battery Junction Box (BJB) cable terminal aside.
-
To install, tighten to 8 Nm (71 lb-in).
5. Remove the starter solenoid terminal cover.
6. Remove the nut and position the battery cable starter solenoid terminal aside.
-
To install, tighten to 12 Nm (106 lb-in).
7. Release the battery cable locator from the engine.
8. Remove the bolt and position the battery cable transaxle ground terminal aside.
-
To install, tighten to 10 Nm (89 lb-in).
9. Release the battery cable locator from the transaxle stud bolt.
10. Release the 3 battery cable locators from the LH valve cover.
11. Position the generator protective cover aside, remove the nut and position the generator B+ terminal aside.
-
To install, tighten to 12 Nm (106 lb-in).
12. Remove the battery cables.
