Fusion FWD V6-3.0L (2009)
Applying hand force to the center of the seal, install the steering gear/dash seal onto the steering gear valve tower until the seal is fully seated in
the valve tower groove.
16. Install the steering gear/dash seal until the retaining clips are fully engaged into the body.
17. NOTICE: Do not allow the steering column to rotate while the steering column shaft is disconnected from the steering gear or damage to
the clockspring may occur. If there is evidence that the steering column has rotated, the clockspring must be removed and recentered. For
additional information, refer to Air Bag Systems.
NOTICE: Make sure to correctly align the index marks when installing the steering gear-to-steering column shaft or unequal right-to-left
turns may occur, causing tire contact with the body and/or clockspring damage.
With the index marks properly aligned, connect the steering column shaft to the steering gear and install the new bolt.
-
Tighten to 25 Nm (18 lb-ft).
18. Install the lower steering column shaft joint cover and the 2 nuts.
19. Fill the power steering system.
20. Check and, if necessary, adjust the front toe.
