Fusion FWD V6-3.0L (2009)
Removal
NOTICE: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure may result
in major service expense. New parts must be installed with the same part numbers or equivalent part, if replacement is necessary. Do not use a
replacement part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure of correct
retention of these parts.
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Detach the 2 wheel speed sensor harness retainers.
3. Remove the wheel speed sensor bolt and position the sensor aside.
4. Disconnect the parking brake cable from the brake caliper in the following sequence.
1. Remove the clip.
2. Disconnect the parking brake cable from the brake caliper.
5. NOTE: Apply the brake to keep the halfshaft from rotating.
Remove and discard the wheel hub nut.
6. NOTICE: Do not allow the brake caliper and anchor plate assembly to hang from the brake hose or damage to the hose can occur.
Remove the anchor plate bolts and position the brake caliper and anchor plate assembly aside.
-
Support the brake caliper and anchor plate assembly using mechanic's wire.
7. Remove the 2 brake disc bolts and the brake disc.
