Fusion FWD V6-3.0L (2009)
Fluid - A/T: Service and Repair
FNR5
Transmission Fluid Drain and Refill
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the transmission fluid cooler return hose from the transaxle.
3. Insert the return hose into a calibrated 10L (10.5 qt) container.
4. NOTICE: To prevent damage to the transaxle, do not run the engine above idle.
NOTE: If the fluid return rate is less than 0.95L (1 qt) in 30 seconds, or if the return hose pulsates, check for restrictions at the pump, transmission
fluid cooler or transmission fluid cooler lines.
Run the engine at idle and pump out 3L (3.17 qt) of transmission fluid.
5. Switch OFF the engine.
6. Remove the transmission fluid level indicator from the transmission fluid level indicator tube.
7. Add 3L (3.17 qt) of transmission fluid to the transaxle.
8. NOTICE: To prevent damage to the transaxle, do not run the engine above idle.
NOTE: If the transmission fluid return rate is less than 0.95L (1 qt) in 30 seconds, or if the return hose pulsates, check for restrictions at the pump,
transmission fluid cooler or transmission fluid cooler lines.
Run the engine at idle and pump out 3L (3.17 qt) of transmission fluid.
9. Switch OFF the engine.
