Fusion FWD V6-3.0L (2009)
3. If equipped, remove the bolts and the splash shield.
4. Remove the front splash shield.
1. Remove the 2 screws.
2. Remove the 4 retainers.
3. Remove the 4 bolts and the splash shield.
5. Disconnect the lower transmission fluid cooler tube from the radiator.
6. NOTICE: Use care not to overstretch or extend the hose clamps as damage may occur to the hose clamp and cause a leak.
NOTICE: The hose clamps are held on the hose with a special epoxy. Damage may occur to the hose if the clamp is removed from the
hose. If the clamp or hose is damaged, install a new fluid cooler tube.
Disconnect the transmission fluid cooler hoses from the transmission fluid cooler tubes.
