Fusion FWD V6-3.0L (2009)
4. NOTICE: Use care not to overstretch or extend the hose clamps as damage may occur to the hose clamp and cause a leak.
NOTICE: The hose clamps are held on the hose with a special epoxy. Damage may occur to the hose if the clamp is removed from the
hose. If the clamp or hose is damaged, install a new fluid cooler tube.
Connect the transmission fluid cooler hoses to the transaxle.
5. Install the lower transmission fluid cooler tube to the radiator.
-
Tighten to 30 Nm (22 lb-ft).
6. Install the front splash shield.
1. Position the splash shield in place and install the 2 screws.
2. Install the 4 retainers.
3. Install the 4 bolts.
