Fusion FWD V6-3.0L (2009)
a. Remove and discard the boot clamps. (Items 1 and 3. Figure 5)
b. Remove and discard the boot. (Item 2, Figure 5)
NOTE
ONCE ALL THE CV JOINT ARE APART AND UTILIZING THE CV BOOT KIT, MAKE SURE NOT TO MIX THE BOOT CLAMPS, AS
THEY HAVE A DIFFERENT DIAMETER.
NOTE
THE CV BOOT KIT PROVIDES TWO (2) TYPES OF GREASE; ONE BOTTLE FOR THE INBOARD CV JOINT NGK302 AND ONE
BOTTLE FOR THE OUTBOARD CV JOINT NGK509.
7. Lubricate the outboard CV joint, doing the following:
a. Pack the outboard CV joint with grease from the kit, make sure the correct outboard joint grease NGK5O9 is applied. (Figure 6)
NOTE
ONE-THIRD OF THE GREASE MUST BE INSTALLED IN THE JOINT WITH THE REMAINDER PLACED IN THE BOOT.
b. Spread the remaining grease evenly inside the boot. (Figure 6)