Fusion FWD V6-3.0L (2009)
Shift Cable: Adjustments
Gearshift Cable Adjustment
1. Set the parking brake.
2. Remove the gearshift knob and the floor console finish panel.
3. Disengage the safety lock by sliding it away from the shifter ball stud.
4. NOTE: If the cable lock is difficult to slide out, disconnect the shift cable from the stud, push the lock from the rear and reattach the shift cable to
the ball stud.
Disengage the cable lock by sliding it out from the shift cable end fitting.
5. Move the shift lever to the center position. With the shifter and the transmission in NEUTRAL, push the cable lock onto the cable.
6. Engage the safety lock by sliding it over the primary shift cable lock.
7. Install the floor console.
