Granada L4-140 2.3L VIN A 2-bbl (1982)
8.
Remove bearing and seal as an assembly using a suitable slide hammer, Fig. 7, if necessary. Two types of bearing are used, Fig. 9. One requires
a light press fit in the housing flange, while on the other a loose fit is acceptable. Therefore, if a loose fitting bearing is encountered, it
does not indicate excessive wear or damage.
9.
Lubricate bearing with rear axle lubricant and install bearing into housing bore using tool No. T78P-1225-A.
10.
Install axle shaft seal into housing using tool No. T78P-1177-A, Fig. 8.
11.
Reverse procedure to install axle shaft.
