NOTE:In order to prevent body distortion while performing repairs, the body must be stabilized on an alignment angle system.
General Notes
Quarter panel and rocker panel are already removed before commencing the repair.
Move carpets and wiring out of the working area.
B-pillar reinforcement
Mill out the spot welds.
Grind out the weld seams.
Installation
NOTE:Before resistance spot welding of body panels with a total panel thickness of 3 mm and greater, the welding equipment instructions contained in sub-section 501-25A must be followed.
B-pillar reinforcement
Drill holes for puddle welding (diameter: 10 mm).
NOTE:Only tack-weld the B-pillar reinforcement at the door cutout. The final welded joint is made with the quarter panel installed.