LTD L4-140 2.3L VIN A 2-bbl (1984)
FIGURE 12
8.
Remove the choke relay connector and install the
(2)
two remaining terminals for circuits #36 and #4 into the choke relay connector cavities as shown in Figure 12. Reinstall the choke relay connector.
9.
Using tie strap #95832-S, strap jumper wire to the 14290 wire harness as required.
Non-A/C Vehicles
Only circuit #4 of jumper wire is required. Do not disturb the tie down taping of terminals for circuit #36.
1.
Using only Circuit #4 (white/black stripe) of jumper wire, follow steps 1-9 above eliminating Step #4.
