LTD Country Squire V8-351 5.8L VIN G Windsor 2-bbl HP (1985)
Air Door Cable: Service and Repair
With Automatic Temperature Control
REMOVAL
1. Disconnect the ground cable from the battery negative (-) terminal.
Instrument Panel Pad Removal And Installation
2. Remove the instrument panel pad.
3. Remove one screw attaching the cable to the Automatic Temperature Control (ATC) sensor and remove the cable from the sensor.
4. Pull the knobs from the radio control shafts.
5. Open the ashtray and remove two screws attaching the center finish panel to the instrument panel at the ashtray opening.
Control Assembly/Center Finish Panel
6. Pull the lower edge of the center finish panel away from the instrument panel and disengage the upper tabs of the finish panel from the instrument
panel.
7. Remove four screws attaching the control assembly to the instrument panel and pull the control out from the opening.
8. Remove the push nut retaining the cable end loop on the temperature lever arm. Then, disconnect the cable housing from the control assembly.
