LTD Country Squire V8-351 5.8L VIN G Windsor 2-bbl HP (1985)
Evaporator Core Removal
3. Position the evaporator core to the right half of the evaporator case.
4. Apply caulking cord D9AZ-19560-A or equivalent sealer to the case flange and around the evaporator core tubes.
5. Position the evaporator case left half and dash panel gasket to the case right half.
6. Install seven screws to attach the two halves of the case together. The center screw on the front of the case also attaches the support strap.
7. Install six screws to attach the dash panel gasket to the case right half.
8. Install a new heat shield on the bottom of the evaporator case assembly and transfer the sensor air scoop to the new dash panel gasket.
9. Install the evaporator case in the vehicle.
