LTD Crown Victoria V8-302 5.0L VIN F FI (1986)
the bearing is aligned with the bearing bore.
3. Stake the bearing in the bearing bore with a blunt drift four equally spaced places around the bearing. Do not use the same locations used to retain
the removed bearing.
4. Clean the pulley bearing surface of the compressor head to remove any dirt or corrosion.
Clutch Pulley Installation
5. Install the pulley and bearing on the compressor. The bearing is a slip fit on the compressor head and, if properly aligned, should slip on the
compressor head. If difficulty is encountered installing the pulley, gently tap the pulley on the compressor using Tool T80L-19703-J or equivalent.
Be sure the pulley bearing is aligned with the compressor head.
6. Install the pulley retaining snap ring with the bevel side of the snap ring out.
Clutch Hub Installation
7. Using the two thickest shims between the hub and the end of the compressor shaft align the shaft key with the keyway in the hub and install the hub
on the compressor shaft. Use Tool T80L-19703-F or equivalent to press the hub on the shaft if necessary. Do not attempt to drive the hub on the
compressor shaft as damage to the compressor will result. Use only the specified tool if the hub will not easily slide on the shaft.
8. Install the hub retaining nut on the compressor shaft and tighten the hub retaining nut to 13-23 Nm (10-14 ft lb).
