LTD Crown Victoria V8-302 5.0L VIN F FI (1986)
Evaporator Case/Plenum Removal/Installation
3. Install two nuts on the studs along the lower flange of the plenum (Fig. 19).
4. Install one bolt below the windshield wiper motor to attach the LH end of the plenum to the dash panel.
Panel Door Vacuum Motor
5. Position panel door vacuum motor to mounting bracket and install two attaching screws.
6. Connect the white vacuum hose to the outside air door vacuum motor.
7. Connect the vacuum jumper harness to the plenum harness at the multiple vacuum connector near the floor air distribution duct.
8. Connect the temperature control cable housing to the bracket on top of the plenum and connect the temperature control cable to the temperature
blend door crank arm. Adjust the temperature cable as outlined under Adjustments.
9. Install the bolt to attach the lower RH end of the instrument panel to the side cowl.
10. Install the RH side cowl trim panel and tighten the RH door sill plate attaching screws.
11. Install instrument panel pad as outlined.
Installation