ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Throttle Valve Cable/Linkage, A/T > < Recall 82V099000: Shift Linkage Defect
Page 1
background image

Throttle Valve Assembly: Technical Service Bulletins
Throttle Valve - Control Pressure Specification Revision

Article No. 86-2-16

TRANSMISSION - AUTOMATIC - AOD - THROTTLE VALVE (TV) CONTROL PRESSURE SPECIFICATION REVISION FOR TV CABLE OR
ROD LINKAGE ADJUSTMENT

FORD 1980-86 FORD, THUNDERBIRD, LTD, MUSTANG

LINCOLN-MERCURY 1980-86 MERCURY, COUGAR, MARQUIS, CAPRI, LINCOLN, CONTINENTAL, MARK

LIGHT TRUCK 1981-86 EAND F-SERIES, BRONCO

In Section 17-20 of the Car and Light Truck Shop Manuals, the TV adjustment procedure linkage using TV control pressure indicates a TV pressure
specification of 35 +/- 5 psi with the best transmission function occurring when the TV pressure is set at 35 psi. These pressures are specified with the
transmission in NEUTRAL.

It is more desirable to have TV pressure at 35 psi when the transmission is in the forward gear ((D) or D). Also, it has been found that when the shift
selector is moved from neutral to a forward gear, the TV pressure goes up approximately 2 psi.

To compensate for the difference in TV pressure between neutral and forward gear, best transmission function will now be obtained with the TV
pressure set at 33 psi in NEUTRAL instead of 35 psi in NEUTRAL. Therefore, whenever adjusting TV cable or rod systems using control pressure, the
acceptable pressure is still 30 to 40 psi (35 +/- 5 psi), but with best transmission function occurring at 33 psi with shift selector in NEUTRAL.

OTHER APPLICABLE ARTICLES: None
WARRANTY STATUS: "INFORMATION ONLY"

Throttle Valve Cable/Linkage, A/T > < Recall 82V099000: Shift Linkage Defect