LTD Crown Victoria V8-351 5.8L VIN G Windsor 2-bbl HP (1982)
screwdriver.
2. To install reverse the process.
3. The 2-door model uses two single switches as the master switch, to remove the single switch(es), remove the switch bezel retaining screw from the
bottom side of the switch (Fig. 8). Then, pivot the lower edge of the bezel out and up to remove the bezel.
4. The switch is held in place by the electrical contact pins. To remove the switch, carefully pry the switch from the connector with a small
screwdriver.
5. To install, position the switch to the connector and press firmly into place.
6. Install the bezel on the switch and install the bezel retaining screw.
7. Install the bezel switch in the vehicle.
