LTD Wagon V8-302 5.0L VIN F 2-bbl (1982)
Pick-Up Coil: Service and Repair
Removal
1. Remove distributor cap and rotor, then disconnect distributor wiring harness plug.
2. Using two screw drivers, pry armature from advance plate sleeve and remove roll pin.
3. Remove snap ring securing pickup assembly to base plate. On 4 and 6 cylinder models, remove washer and wave washer.
4. On all models, remove snap ring securing vacuum advance link to pickup assembly.
5. Remove pickup assembly ground screw and lift assembly from distributor.
6. Disconnect vacuum advance link from pickup assembly post.
Installation
1. Position pickup assembly over base plate and slide wiring harness into slot on side of distributor housing.
2. On 4 and 6 cylinder models, install washers. On all models, install snap ring securing pickup assembly to base plate.
3. Position vacuum advance link on pickup assembly post and install snap ring.
4. Insert ground screw through wiring harness tab and install on base plate.
5. Install armature on advance plate sleeve, ensure roll pin is engaged in slot.
6. Install distributor rotor and cap, then connect distributor wiring harness plug to vehicle wiring harness.
