Replacing Ignition Lock Cylinder Housing for 1982 LTD Wagon V8-302 50L VIN F 2-bbl
Ignition Lock: Service and Repair
Ignition Lock Replace
1982---88
1.
Disconnect battery ground cable.
2.
Remove steering column trim shroud.
3.
Disconnect key warning switch electrical connector.
4.
Turn ignition lock to ``On'' or ``Run'' position.
5.
Using a {1-8} inch pin or punch located in the 4 o'clock hole and 1{1-4} inch from outer edge of lock cylinder housing, depress retaining pin
while pulling the lock cylinder from housing.
6.
Turn lock cylinder to ``On'' or ``Run'' position and insert cylinder into housing. Ensure that the lock cylinder is fully seated and aligned into the
interlocking washer before turning key to ``Off'' position. This will permit the retaining pin to extend into the lock cylinder housing hole.
7.
Rotate key to check for proper mechanical operation.
8.
Connect key warning switch electrical connector.
9.
Connect battery ground cable.
10.
Check for proper operation.
