LTD Wagon V8-302 5.0L VIN F 2-bbl (1982)
Testing of the power window master switch should be performed with the switch removed from the vehicle. Use a self-powered test lamp or an
ohmmeter.
1. Clip one test lead probe on terminal 3, which is grounded.
2. With all switches in the NEUTRAL position, terminals 4 through 11 should have continuity to terminal 3.
3. Push all four window switches upward (toward window of vehicle when in installed position).
All odd numbered terminals should lose continuity to terminal 3.
4. Push all four window switches downward (away from window when in installed position).
All even numbered terminals 4 through 10 should lose continuity to terminal 3.
5. Remove the test lead from terminal 3 and connect it to terminal 2 (hot feed terminal).
With all switches in the NEUTRAL position, only terminal 1 should have continuity to terminal 2.
6. Push all four switches upward and hold in that position.
All odd numbered terminals should have continuity to terminal 2.
7. Pull all four switches downward and hold in that position.
All even numbered terminals should have continuity to terminal 2.
8. Push the lock out switch to its detent position.
Terminal 2 should NOT have continuity with any other terminal.
9. If any one switch does not test as outlined, replace the complete switch assembly.
