| General Procedures | | -
Body dimensions, front end. - All dimensions with tolerance ± 3mm. All dimensions were measured from the centre of the hole or the edge of the panel with a symmetrically adjusted beam trammel.
- 1 - 5 = 1420 mm; 2 - 3 = 802 mm; 4 - 8 = 642 mm; 6 - 7 = 728 mm; 6 - 9 = 1582 mm.
| | | -
Body dimensions, side view. - All dimensions with tolerance ± 3mm. All dimensions were measured from the centre of the hole or the edge of the panel with a symmetrically adjusted beam trammel.
- 10 - 18 = 893 mm; 10 - 19 = 963 mm; 11 - 15 = 1397 mm; 11 - 19 = 1101 mm; 12 - 20 = 1364 mm; 13 - 16 = 1078 mm; 14 - 17 = 1176 mm; 15 - 18 = 846 mm.
| | | -
Body dimensions, rear view. - All dimensions with tolerance ± 3mm. All dimensions were measured from the centre of the hole or the edge of the panel with a symmetrically adjusted beam trammel.
- 21 - 27 = 940 mm; 22 - 28 = 1262 mm; 23 - 32 = 1425 mm; 24 - 31 = 1453 mm, 25 - 30 = 1416 mm; 26 - 29 = 1285 mm.
| | |
