Removal and Installation Removal | -
NOTE:When removing the rocker panel moulding, start at one end and proceed to the oppsite end of the moulding. Remove the rocker panel moulding screws. | | -
If equipped, remove the six step bar bracket bolts, and the step bar. | | -
Remove the six rocker panel moulding pin-type retainers. | | -
NOTE:When removing the rocker panel moulding use a wedge type tool to assist in the removal, start at one end and proceed to the opposite end. NOTE:The rocker panel moulding retainer clips are one-time use only. New clips must be used during installation. Remove the rocker panel moulding. | Installation | -
To install, reverse the removal procedure. | | |