ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Front End - Clunk/Pop Noise On Turns|Page 5556 > < Brake Bleeding|Service and Repair
Page 1
background image

Brake Caliper: Customer Interest
Front End - Clunk/Pop Noise On Turns

Article No. 85-4-31

NOISE CLUNK/POP IN FRONT END ON TURNS WITH BRAKES APPLIED

FORD 1984-85 THUNDERBIRD, LTD, MUSTANG

LINCOLN-MERCURY 1984-85 COUGAR, MARQUIS, CAPRI

This article outlines the procedure to service vehicles which may exhibit a clunk/pop noise in the front end when turning with the brakes applied. This
procedure is to be performed on both right and left sides of the vehicle. This condition does not affect vehicle handling.

1.

Raise the vehicle on a hoist.

2.

Remove the tire and wheel assembly.

3.

Check the two lower suspension arm inner pivot nuts and bolts for proper torque. If loose, torque to 190-203 Nm (140-150 ft.lb.).

4.

Check the two nut sand bolts that attach the strut to the spindle for proper torque. If loose, torque to 230-244 Nm (170-180 ft.lb.).

Front End - Clunk/Pop Noise On Turns|Page 5556 > < Brake Bleeding|Service and Repair