ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Clutch Pedal Position (CPP) Switch > < Heated Oxygen Sensor (HO2S) - 1.6L-1.8L-2.0L

Mondeo 1997 (08.1996-09.2000)

Electronic Engine Controls - Heated Oxygen Sensor (HO2S) RH—2.5L Mondeo 1997 (08/1996-09/2000)
Removal and Installation

Removal

  1. Remove the ignition coil. For additional information, refer to Section  303-07A Engine Ignition / 303-07B Engine Ignition.

  1. Disconnect the heated oxygen sensor electrical connector.

  1. Remove the heated oxygen sensor (shown from under the vehicle for clarity).

Installation

CAUTION:
CAUTION:When installing a new HO2S, it is possible that the new component will be supplied with a longer cable than the one removed. It is important that the cable is routed and secured in such a way that it cannot be damaged by heat or moving components and will not cause a noise, vibration or harshness (NVH) issue.
  1. Install the components in reverse order.

Clutch Pedal Position (CPP) Switch > < Heated Oxygen Sensor (HO2S) - 1.6L-1.8L-2.0L