ford Workshop Repair Guides

Ford Mondeo Workshop Service and Auto Repair Manuals - Maintenance Guide

ABOUT US
Rear Seat Backrest > < Diagnosis and Testing|Seats

Mondeo 1997 Front Seat Removal and Installation Guide

Seating - Front Seat Mondeo 1997 (08/1996-09/2000)
Removal and Installation

Removal

All Vehicles
  1. WARNING:
    WARNING:To avoid accidental deployment the air bag control module backup power supply must be depleted. Wait at least one minute after disconnecting the battery ground cable(s) before commencing any repair or adjustment to the supplemental restraint system (SRS), or any component(s) adjacent to the SRS sensors. Failure to follow these instructions may result in personal injury.
    WARNING:
    WARNING:Always wear safety glasses when working on an air bag equipped vehicle and when handling an air bag module. Failure to follow this instruction may result in personal injury.
    Disconnect the battery ground cable. For additional information, refer to Section  414-01 Battery, Mounting and Cables.

  1. Detach the safety belt lower anchor from the underside of the seat.
  1. Move the seat fully forwards.

  1. Remove the seat track trims (right-hand side shown).
    • Remove the screws.

  1. Remove the seat rear retaining bolts (right-hand side shown).
  1. Move the seat fully rearwards.

  1. Remove the seat front retaining bolts (right-hand side shown).

  1. Disconnect the safety belt pretensioner electrical connector.
Vehicles with power seats
  1. Disconnect the electrical connector.
Vehicles with side air bag
  1. Disconnect the side air bag module electrical connector.
All Vehicles
  1. Disconnect the heated seat electrical connectors (if equipped).
  1. Remove the seat.

Installation

  1. To install, reverse the removal procedure.

Rear Seat Backrest > < Diagnosis and Testing|Seats