ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Cooling Fan Motor and Shroud - 2.0L Duratorq-Di-TDDi (Puma) Diesel-2.0L Duratorq-TDCi (Puma) Diesel-2.2L Duratorq-TDCi (Puma) Di > < Cooling Fan Motor and Shroud - 1.8L Duratec-SCi (MI4)

Mondeo 2001 (10.2000-02.2007)

Engine Cooling - Cooling Fan Motor and Shroud Mondeo 2001 (10/2000-02/2007)
Removal and Installation

Removal

All vehicles
  1. Disconnect the battery ground cable. For additional information, refer to Section  414-01 Battery, Mounting and Cables.
  1. Raise and support the vehicle. For additional information, refer to Section  100-02 Jacking and Lifting.
Vehicles with 2.0L diesel engine
  1. Remove the engine undershield.
All vehicles
  1. Remove the splash shield.

  1. Using suitable pieces of wire support the radiator.

  1. Disconnect the cooling fan motor electrical connectors and detach the wiring harness from the radiator support bracket.
Vehicles with 2.5L engine
  1. Disconnect the cooling fan motor electrical connector.
All vehicles
  1. Remove the radiator support bracket retaining bolts.

  1. Remove the cooling fan motor and shroud.
    1. Remove the cooling fan motor and shroud retaining nuts.
    1. Slide the cooling fan motor and shroud upwards out of the retaining brackets and then downwards to remove.

Installation

  1. To install, reverse the removal procedure.

Cooling Fan Motor and Shroud - 2.0L Duratorq-Di-TDDi (Puma) Diesel-2.0L Duratorq-TDCi (Puma) Diesel-2.2L Duratorq-TDCi (Puma) Di > < Cooling Fan Motor and Shroud - 1.8L Duratec-SCi (MI4)