ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
303-14B Electronic Engine Controls - 1.8L Duratec-HE (MI4)-2.0L Duratec-HE (MI4) > < Rear Knock Sensor (KS)

Mondeo 2001 (10.2000-02.2007)

Electronic Engine Controls - 1.8L Duratec-SCi (MI4) - Crankshaft Position (CKP) Sensor Mondeo 2001 (10/2000-02/2007)
Removal and Installation

Special Tool(s)

Alignment Tool, Crankshaft Position Sensor

303-1060
General Equipment
Bolt, M6 x 18 mm
  1. Raise and support the vehicle.
    For additional information, refer to: Lifting (100-02 Jacking and Lifting, Description and Operation).

  1. Remove the splash shield

  1. CAUTION:
    CAUTION:Only turn the crankshaft pulley in the normal direction of rotation.
    CAUTION:
    CAUTION:Tighten the M6 x 18 mm bolt finger-tight only.
    Rotate the crankshaft pulley clockwise until the crankshaft pulley timing bolt, M6 x 18 mm can be installed through the crankshaft pulley timing hole into the engine front cover.

4. Remove the components in the order indicated in the following illustration(s) and table(s).

 
Item
Part Number
Description
1
-
CKP sensor electrical connector
2
-
CKP sensor retaining bolt
3
-
CKP sensor
See Installation Detail
4
-
CKP sensor bracket retaining bolts
See Installation Detail
5
-
CKP sensor bracket

5. To install, reverse the removal procedure.

Installation Details

Item 4 : CKP sensor bracket retaining bolts

  1. Install the CKP sensor bracket retaining bolts finger tight.

Item 3 : CKP sensor
  1. Align the CKP sensor bracket.
    • Install the special tool to the CKP sensor bracket.
    • Tighten the CKP sensor bracket retaining bolts.
    • Remove the special tool.
  1. Install the CKP sensor

303-14B Electronic Engine Controls - 1.8L Duratec-HE (MI4)-2.0L Duratec-HE (MI4) > < Rear Knock Sensor (KS)