ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Front Knock Sensor (KS) > < Powertrain Control Module (PCM)

Mondeo 2001 (10.2000-02.2007)

Electronic Engine Controls - 1.8L Duratec-SCi (MI4) - Injector Driver Module (IDM) Mondeo 2001 (10/2000-02/2007)
Removal and Installation

General Equipment
Worldwide Diagnostic System (WDS)
NOTE:
NOTE:If a new IDM is being installed connect WDS. Upload the IDM configuration information using the programmable modules installation routine prior to commencing the removal of the IDM.

1. Remove the components in the order indicated in the following illustration(s) and table(s).

 
Item
Part Number
Description
1
-
Left-hand strut and spring assembly top mount brace cover.
2
-
Left-hand strut and spring assembly top mount brace
3
-
IDM electrical connector retaining bolt
4
-
IDM electrical connector
5
-
IDM
See Removal Detail

2. To install, reverse the removal procedure.

NOTE:
NOTE:If a new IDM is being installed connect WDS. Download the IDM configuration information using the programmable modules installation routine after the installation of the IDM.

Removal Details

Item 5 : IDM
  1. Remove the IDM.
    1. Release the IDM housing locking tangs.
    1. Pull the IDM up from the IDM housing.

Front Knock Sensor (KS) > < Powertrain Control Module (PCM)