ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Heated Oxygen Sensor (HO2S) RH > < Electronic Engine Controls

Mondeo 2001 (10.2000-02.2007)

Electronic Engine Controls - 2.5L Duratec-VE (VE6)/3.0L Duratec-SE (VE6)/3.0L Duratec-ST (VE6) - Heated Oxygen Sensor (HO2S) LH Mondeo 2001 (10/2000-02/2007)
Removal and Installation

Removal
  1. Remove the engine cover.

  1. Disconnect the left-hand HO2S electrical connector.
  1. Raise and support the vehicle. For additional information, refer to Section  100-02 Jacking and Lifting.

  1. Remove the left-hand HO2S.

Installation

CAUTION:
CAUTION:When installing a new HO2S, it is possible that the new component will be supplied with a longer cable than the one removed. It is important that the cable is routed and secured in such a way that it cannot be damaged by heat or moving components and will not cause a noise, vibration or harshness (NVH) issue.
  1. To install, reverse the removal procedure.

Heated Oxygen Sensor (HO2S) RH > < Electronic Engine Controls