| Removal and Installation Name Specification Grease SA-M1C9107-A Removal | | -
Raise and support the vehicle.
For additional information, refer to: Jacking (100-02 Jacking and Lifting, Description and Operation) /
Lifting (100-02 Jacking and Lifting, Description and Operation).
| | | -
CAUTION:Over bending of the exhaust flexible pipe may cause damage resulting in failure. Support the exhaust flexible pipe with a suitable support wrap or suitable splint. | | | -
Disconnect the catalyst monitor sensor electrical connector. | | | -
Detach the catalyst monitor sensor wiring harness from the floor panel heat shield. | | | -
Remove the catalyst monitor sensor. | | | -
Detach the dual converter Y-pipe from the catalytic converter. - Discard the gasket and nuts.
| | | -
Remove the catalytic converter. - Discard the gasket and nuts.
| Installation | | -
CAUTION:Never use jointing compound forward of the catalytic converter. NOTE:Coat the catalytic converter studs with anti-seize grease. NOTE:Install new catalytic converter gaskets and nuts. To install, reverse the removal procedure. | | |
