ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Catalytic Converter RH - 3.0L Duratec-ST (VE6) > < Catalytic Converter - 1.8L Duratec-HE (MI4)-2.0L Duratec-HE (MI4)

Mondeo 2001 (10.2000-02.2007)

Exhaust System - Catalytic Converter LH—3.0L Duratec-ST (VE6) Mondeo 2001 (10/2000-02/2007)
Removal and Installation

Materials
Name
Specification
Anti-seize grease
SAM–1C9107-A 

Removal

  1. Remove the left-hand exhaust flexible pipe.
    For additional information, refer to Exhaust Flexible Pipe in this section.

  1. Remove the catalyst monitor sensor.
    1. Disconnect the electrical connector.
    1. Remove the sensor.

  1. Detach the catalytic converter from the support bracket.
  1. Lower the vehicle.

  1. Detach the ignition coil pack from the left-hand valve cover and position it to one side.

  1. Remove the catalytic converter.
    • Discard the gasket and nuts.

  1. Remove the catalytic converter retaining studs.
    • Discard the retaining studs.

Installation

  1. CAUTION:
    CAUTION:Never use jointing compound forward of the catalytic converter.
    NOTE:
    NOTE:Coat the catalytic converter retaining studs with anti-seize grease.
    NOTE:
    NOTE:Install a new catalytic converter gasket, retaining studs and nuts.
    To install, reverse the removal procedure.

Catalytic Converter RH - 3.0L Duratec-ST (VE6) > < Catalytic Converter - 1.8L Duratec-HE (MI4)-2.0L Duratec-HE (MI4)