ford Workshop Repair Guides

Ford Mondeo Workshop Service and Auto Repair Manuals

ABOUT US
501-20A Safety Belt System > < Rear Bumper Cover - 3.0L Duratec-ST (VE6)

Removal and Installation of Rear Bumper Cover for Mondeo 2001 - Mechanical Repairs

Bumpers - Rear Bumper Cover—1.8L Duratec-HE (MI4)/1.8L Duratec-SCi (MI4)/2.5L Duratec-VE (VE6)/2.0L Duratorq-Di/TDDi (Puma) Diesel/2.0L Duratorq-TDCi (Puma) Diesel/2.2L Duratorq-TDCi (Puma) Diesel Mondeo 2001 (10/2000-02/2007)
Removal and Installation

Removal

4-door
  1. Remove the bumper cover retaining screws.
All vehicles
  1. Raise and support the vehicle. For additional information, refer to Section  100-02 Jacking and Lifting.

  1. Detach the fender splash shield from the bumper cover on both sides.

  1. Detach the bumper cover from the fender on both sides.
Wagon
  1. Detach the bumper cover from the spare wheel housing.
4-door and 5-door
  1. Detach the bumper cover from the spare wheel housing.
All vehicles
  1. Detach the parking aid sensors from the bumper cover (if equipped).
  1. Remove the bumper cover.

Installation

  1. To install, reverse the removal procedure.

501-20A Safety Belt System > < Rear Bumper Cover - 3.0L Duratec-ST (VE6)