ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Rear Bumper Cover - 1.8L Duratec-HE (MI4)-1.8L Duratec-SCi (MI4)-2.5L Duratec-VE (VE6)-2.0L Duratorq-Di-TDDi (Puma) Diesel-2.0L > < Front Bumper Cover

Mondeo 2001 (10.2000-02.2007)

Bumpers - Rear Bumper Cover—3.0L Duratec-ST (VE6) Mondeo 2001 (10/2000-02/2007)
Removal and Installation

Removal

4-door
  1. Remove the bumper cover retaining screws.
All vehicles
  1. Raise and support the vehicle. For additional information, refer to Section  100-02 Jacking and Lifting.

  1. Detach the fender splash shield from the bumper cover on both sides.

  1. Detach the bumper cover from the fender on both sides.

  1. Detach the bumper cover from the spare wheel housing.

  1. Detach the parking aid sensors from the bumper cover (if equipped).
  1. Remove the bumper cover.

Installation

  1. To install, reverse the removal procedure.

Rear Bumper Cover - 1.8L Duratec-HE (MI4)-1.8L Duratec-SCi (MI4)-2.5L Duratec-VE (VE6)-2.0L Duratorq-Di-TDDi (Puma) Diesel-2.0L > < Front Bumper Cover