General Procedures | -
Frame Dimensions - 4-/5-door versions - All dimensions have a tolerance of ± 3 mm. The detailed illustrations show the left-hand side of the vehicle. All dimensions are measured from the centre of the hole with a symmetrically adjusted beam trammel and with the assemblies removed.
- The longitudinal measurements are projected co-ordinate measurements, which must be measured from a parallel flat bearing face (not with the beam trammel). The width measurements can be measured with a symmetrically adjusted beam trammel.
| | -
Frame Dimensions - 4-/5-door versions - All dimensions have a tolerance of ± 3 mm. The detailed illustrations show the left-hand side of the vehicle. All dimensions are measured from the centre of the hole with a symmetrically adjusted beam trammel and with the assemblies removed.
- The diagonal measurements can be measured with a symmetrically adjusted beam trammel.
| | -
Frame Dimensions - estate version - All dimensions have a tolerance of ± 3 mm. The detailed illustrations show the left-hand side of the vehicle. All dimensions are measured from the centre of the hole with a symmetrically adjusted beam trammel and with the assemblies removed.
- The longitudinal measurements are projected co-ordinate measurements, which must be measured from a parallel flat bearing face (not with the beam trammel). The width measurements can be measured with a symmetrically adjusted beam trammel..
| | -
Frame Dimensions - estate version - All dimensions have a tolerance of ± 3 mm. The detailed illustrations show the left-hand side of the vehicle. All dimensions are measured from the centre of the hole with a symmetrically adjusted beam trammel and with the assemblies removed.
- The diagonal measurements can be measured with a symmetrically adjusted beam trammel.
| | |